[450] Woody is loopy...
djmay at comcast.net
djmay at comcast.net
Sun Jul 5 10:52:40 EDT 2009
Thank-you, Robert, I'm off...
----- Original Message -----
From: "Bob" <N1UJS at toast.net>
To: "144.450 Mailing List" <450 at lists.vhfwiki.com>
Sent: Sunday, July 5, 2009 11:44:55 AM GMT -05:00 US/Canada Eastern
Subject: Re: [450] Woody is loopy...
Depends....since you've upgraded, the whole band is yours!
Since the very top is repeaters, how about 28.400 and 28.500 ?
----- Original Message -----
From: djmay at comcast.net
To: 144.450 Mailing List
Sent: Sunday, July 05, 2009 9:11 AM
Subject: Re: [450] Woody is loopy...
I will post them when the project is complete ! Also, what do you think for a target to tune the 10m halo?
----- Original Message -----
From: n1ujs at toast.net
To: 450 at lists.vhfwiki.com
Sent: Sunday, July 5, 2009 9:37:41 AM GMT -05:00 US/Canada Eastern
Subject: Re: [450] Woody is loopy...
Where are the pictures?????!!!!!!!
------- Original Message -------
>From : djmay at comcast.net[mailto:djmay at comcast.net]
Sent : 7/5/2009 7:40:16 AM
To : 450 at lists.vhfwiki.com
Cc :
Subject : RE: Re: [450] Woody is loopy...
I must have just missed you guys. I'm getting a 1.4 - 1.5 SWR over the 50.1 - 50.4 frequency
range. It wouldn't sink any further, even when standing alone on the mast. That's not too bad and
I can use the radio's internal antenna tuner, also. I also was able to get the 2m stacked pair up
on that mast, so now I shouldn't have to take that mast down again. I was able to sink the stacked
pair dead flat. I'm going to see if I can get the 10m halo up on the other mast today (I'll have
to drop it , of course,) and then I'll be done !! (For now.) I'm also going to forego the guy
wires and use the threaded rod for supports, as you suggested. I can see this will be very
beneficial with the 20 ft. mast that has the 6m halo and stacked pair on it.
----- Original Message -----
From: n1ujs at toast.net
To: 450 at lists.vhfwiki.com
Sent: Sunday, July 5, 2009 7:30:48 AM GMT -05:00 US/Canada Eastern
Subject: Re: [450] Woody is loopy...
Did it "sink" nicely on the low end of the band?
Bandwidth enough to happily cover 50-50.4?
Rich and I were on at 11:00 and hoped to hear it.
Rich would be a good test.
------- Original Message -------
>From : djmay at comcast.net[mailto:djmay at comcast.net]
Sent : 7/5/2009 5:34:07 AM
To : 450 at lists.vhfwiki.com
Cc :
Subject : RE: Re: [450] Woody is loopy...
Yes, Bob, it's up and tuned. I was on from about 8 - 11 last night, but only heard Larry in
there on 2m. I went on 6m very briefly and spoke with KB1UFO (Bristol, CT) and heard a QSO
between him and K0XXX (Arkansas,) although Arkansas was in the back of the box.
----- Original Message -----
From: n1ujs at toast.net
To: 450 at lists.vhfwiki.com
Sent: Sunday, July 5, 2009 3:11:34 AM GMT -05:00 US/Canada Eastern
Subject: [450] Woody is loopy...
Hey! What happened? Any luck with the loop?
_______________________________________________
450 mailing list
450 at lists.vhfwiki.com
http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450
_______________________________________________
450 mailing list
450 at lists.vhfwiki.com
http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450
_______________________________________________
450 mailing list
450 at lists.vhfwiki.com
http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450
_______________________________________________
450 mailing list
450 at lists.vhfwiki.com
http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450
_______________________________________________ 450 mailing list 450 at lists.vhfwiki.com http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vhfwiki.com/pipermail/450/attachments/20090705/dba1f4f5/attachment.html>
-------------- next part --------------
_______________________________________________
450 mailing list
450 at lists.vhfwiki.com
http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450
More information about the 450
mailing list