[450] Woody is loopy...

[Bob]

OK fine!
I am off shortly as well....spending the afternoon at Hop Brook in your neighborhood....anyone gets bored, stop in.....I'll be at the big pavillion with the volleyball nets by the lake....
  ----- Original Message ----- 
  From: djmay at comcast.net 
  To: 144.450 Mailing List 
  Sent: Sunday, July 05, 2009 9:52 AM
  Subject: Re: [450] Woody is loopy...


  Thank-you, Robert,  I'm off...




  ----- Original Message -----
  From: "Bob" <N1UJS at toast.net>
  To: "144.450 Mailing List" <450 at lists.vhfwiki.com>
  Sent: Sunday, July 5, 2009 11:44:55 AM GMT -05:00 US/Canada Eastern
  Subject: Re: [450] Woody is loopy...

   

  Depends....since you've upgraded, the whole band is yours!  
  Since the very top is repeaters, how about 28.400 and 28.500 ?
    ----- Original Message ----- 
    From: djmay at comcast.net 
    To: 144.450 Mailing List 
    Sent: Sunday, July 05, 2009 9:11 AM
    Subject: Re: [450] Woody is loopy...


    I will post them when the project is complete !   Also, what do you think for a target to tune the 10m halo?




    ----- Original Message -----
    From: n1ujs at toast.net
    To: 450 at lists.vhfwiki.com
    Sent: Sunday, July 5, 2009 9:37:41 AM GMT -05:00 US/Canada Eastern
    Subject: Re: [450] Woody is loopy...

    Where are the pictures?????!!!!!!!



    ------- Original Message -------
    From    : djmay at comcast.net[mailto:djmay at comcast.net]
    Sent    : 7/5/2009 7:40:16 AM
    To      : 450 at lists.vhfwiki.com
    Cc      : 
    Subject : RE: Re: [450] Woody is loopy...

     I must have just missed you guys.  I'm getting a  1.4 - 1.5  SWR over the 50.1 - 50.4  frequency 
    range.  It wouldn't sink any further, even when standing alone on the mast. That's not too bad and 
    I can use the radio's internal antenna tuner, also. I also was able to get the 2m stacked pair up 
    on that mast, so now I shouldn't have to take that mast down again. I was able to sink the stacked 
    pair dead flat.  I'm going to see if I can get the 10m halo up on the other mast today (I'll have 
    to drop it , of course,) and then I'll be done !!  (For now.)  I'm also going to forego the guy 
    wires and use the threaded rod for supports, as you suggested.  I can see this will be very 
    beneficial with the 20 ft. mast that has the 6m halo and stacked pair on it.
     
     
    ----- Original Message -----
    From: n1ujs at toast.net
    To: 450 at lists.vhfwiki.com
    Sent: Sunday, July 5, 2009 7:30:48 AM GMT -05:00 US/Canada Eastern
    Subject: Re: [450] Woody is loopy...

    Did it "sink" nicely on the low end of the band?
    Bandwidth enough to happily cover 50-50.4?
    Rich and I were on at 11:00 and hoped to hear it.
    Rich would be a good test.



    ------- Original Message -------
    From    : djmay at comcast.net[mailto:djmay at comcast.net]
    Sent    : 7/5/2009 5:34:07 AM
    To      : 450 at lists.vhfwiki.com
    Cc      : 
    Subject : RE: Re: [450] Woody is loopy...

     Yes, Bob, it's up and tuned.  I was on from about 8 - 11 last night, but only heard Larry in 
    there on 2m.  I went on 6m very briefly and spoke with KB1UFO (Bristol, CT)  and heard a QSO 
    between him and K0XXX  (Arkansas,)  although Arkansas was in the back of the box.
     

    ----- Original Message -----
    From: n1ujs at toast.net
    To: 450 at lists.vhfwiki.com
    Sent: Sunday, July 5, 2009 3:11:34 AM GMT -05:00 US/Canada Eastern
    Subject: [450] Woody is loopy...

    Hey!  What happened?  Any luck with the loop?

    _______________________________________________
    450 mailing list
    450 at lists.vhfwiki.com
    http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450


    _______________________________________________
    450 mailing list
    450 at lists.vhfwiki.com
    http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450


    _______________________________________________
    450 mailing list
    450 at lists.vhfwiki.com
    http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450




----------------------------------------------------------------------------


    _______________________________________________
    450 mailing list
    450 at lists.vhfwiki.com
    http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450


  _______________________________________________ 450 mailing list 450 at lists.vhfwiki.com http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450 


------------------------------------------------------------------------------


  _______________________________________________
  450 mailing list
  450 at lists.vhfwiki.com
  http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vhfwiki.com/pipermail/450/attachments/20090705/cc6c3fbd/attachment.html>
-------------- next part --------------
_______________________________________________
450 mailing list
450 at lists.vhfwiki.com
http://lists.vhfwiki.com/cgi-bin/mailman/listinfo/450